How to use SRT 220 – DiSEqC Switch ?

SRT 220 is designed to switch between 2 satellite (SAT) feeds, using “Uncommitted_1” DiSEqC commands provided by the SAT receiver.

Installation and Operation:

Connect the 2 SAT feeds to the LNB A and LNB B inputs of SRT 220. When using SRT 220 to select between the outputs of different MultiSwitch systems, make sure you connect the LNB A and LNB B inputs to the corresponding taps on the MultiSwitch.

Then, connect the REC output to your SAT receiver, using adequately shielded coaxial cable terminated with F-type connectors. SRT 220 may be used to switch between the outputs of Universal LNBs, DiSEqC switches or DiSEqC controlled MultiSwitch systems, or any combination thereof.

How-to-use-SRT-220---2-Universal-Single-LNB-

The illustration above shows SRT 220 switching between the outputs of 2 Universal Single LNBs.

How to use SRT 220 with 2 Universal TwinLNB

 The illustration above shows 2 SRT 220 switching between the outputs of 2 Universal Twin LNBs

How-to-use-SRT-220-in-distribution-system-configuration-

The illustration above shows 4 SRT 220 switching between the outputs of 2 MultiSwitch systems. “Option” DiSEqC commands will switch between the SRT 220 inputs, while “position” DiSEqC commands will control the MultiSwitches (SRT 9004 and SRT 5004, in this instance).

How-to-use-SRT-220-in-distribution-system-configuration-2-

The illustration above shows SRT 220 switching between the outputs of 2 MultiSwitch systems. “Uncommitted_1” DiSEqC commands will switch between the SRT 220 inputs, while “option” and “position” DiSEqC commands will control the MultiSwitches (SRT 1780, in this instance)